Digi Connect Series

Configurethedeviceusing theweb interface Serial portsconfiguration
Digi Connect Family and ConnectPort TSFamily
88
e. Specify the destination TCPport number in the TCP Port field. The port
number dependson the conventions used on the remote server or device.
Thefollowing table provides the common TCPport number conventions.
Connection Service Common TCP Port Number
Telnet 23
Rlogin 513
Reverse Telnet to the port of the
Digi device server
Theformat for thisport number is
as follows:
20<serial port number>
Replace <serial port number> with
the Digi serial port number. For
example, 2001 appliesto serial port
1, 2010 appliesto serial port 10, and
2016 applies to serial port 16.
2001
Raw connection to the port of the
Digi device server
Theformat for thisport number is
as follows:
21<serial port number>
Replace <serial port number> with
the Digi serial port number. For
example, 2101 appliesto serial port
1, 2110 appliesto serial port 10, and
2116 applies to serial port 16.
2101
f. Click Apply to savethe configuration.
g. Click Basic Serial Settings, complete the fieldsto match the settings of the
attached serial device or terminal, and then click Apply.