Digi Connect Series

Configurethedeviceusing theweb interface Serial portsconfiguration
Digi Connect Family and ConnectPort TSFamily
94
n
Send when data ispresent on the serial line: Send the data to the network destinations
when a string of characters is detected in the serial data. To enter non-printable characters,
use these key sequences:
Character
Key
Sequence
hexadecimal
values
\xhh
tab \t
line feed \n
backslash \\
n
Match string: A1 to 4 character string. Thisisusually the newline character sequence but can
also be a custom string of 1 to 4characters.
n
Strip match string before sending: Search for thestring specified in the Match String field
before sending the data and strip the string from the string from the data before it issent to
the destination.
n
Send after the following number of idle milliseconds: Send the data after the specified
number of millisecondshave passed with no data received on the serial port.
n
Send after the following number of bytes: Send the data after the specified number of bytes
have been received on the serial ports.
n
Close connection after the following number of idle seconds: Enable to close an idle
connection. Use the Timeout field to enter thenumber of secondsthat the connection will be
idle before it isclosed. This can be 1 to 65000 seconds.
n
Close connection when DCD goes low: When selected, the connection will be closed when
the DCD(Data Carrier Detected) signal goes low.
Note If you are using 8-wire cabling, you must apply the altpin for DCDfunctionality.
n
Close connection when DSRgoes low: When selected, the connection will be closed when
the DSR(Data Set Ready) signal goes low.
UDP settings
TheseUDPSettingsareavailable only when the current port isconfigured with the Console
management, the UDPSockets, or the Custom Profile.
n
Send Socket ID: Include an optional identifier string with the data sent over the network.
TheSocket IDcan be 1 to 256 ASCII characters. Enter non-printable characters as
follows: