Digilite Pulse MX - Page 67

67
PULSE MX
DMX-In Disable
DMX playbacks control global disable. If this button is on, the console will ignore all the rest of the
conguration and the playbacks control by DMX input is inhibited.
Go/Rel. Enable
Trigger and Release receive command enable. Two DMX channels for each DMX controlled playback
are used if this button is selected.
Go/Rel. Disable
Trigger and Release receive command disable . Only the intensity master of playbacks is controlled
if this button is selected
OK
If the new conguration is error free, it will be activated and saved on the disk and the conguration
window will be closed, otherwise an error message will appear.
Cancel
It aborts all the changes made and goes back to the Setup Menu.
First playback to map
This is the rst playback that you will control by the external DMX device. You can control up to 24
Playbacks.
Total playbacks to map
This value is the total number of playbacks that will be controlled by the external DMX device. Since
you can control the playbacks ranging from 1 to 24, the sum of First Playback To Map and Total play-
backs to map elds has to be not above 25
DMX Start Address
This is the rst of the n DMX channels used to control the playbacks intensity master (with n equal
to the Total playbacks to map value)
Go/Release DMX Start Address
This is the rst of the n DMX channels used to send Trigger and release commands to playbacks (with
n equal to the Total playbacks to map value)
Using the DMX channel that controls the playbacks intensity master is useful to address the cue
storing: If you move a slider after pressing the Store key, the cue will be saved on the register control-
led by the slider moved.
The Go/Release channel works in the following way:
• A trigger will be sent to the playback when the channel reach 100%
• When the channel value goes down to 0% a release command is sent.
If you use a console having sliders and ash buttons you can set the sliders position at about 50%
and use ash keys for to send triggers and move down the sliders to 0% to send Release commands
IMPORTANT: The DMX remote playbacks control has priority over built-in controllers. If the same playback
is congurated in order to be controlled by a built in slider and by an external DMX device, the DMX device
will take precedence and the built-in slider will be disabled.