Digilite Pulse MX - Page 69

69
PULSE MX
OK
If the new conguration is error free, it will be activated and saved on the disk and the conguration
window will be closed, otherwise an error message will appear.
Cancel
It aborts all the changes made and goes back to the Setup Menu.
Total controllers to map
This value is the total number of manual cues that will be controlled by the external DMX device. You
can control up to 288 manual cues that means all the manual cues of all the console banks.
DMX Start Address
This is the rst of the n DMX channels used to control the manual cue sliders (with n equal to the Total
Controllers to map value)
Flash/Release DMX Start Address
This is the rst of the n DMX channels used to ash and send release commands to controllers (with
n equal to the Total Controller s to map value)
Using the DMX channel that controls the manual cue sliders is useful to address the manual cue
storing : if you move a slider after pressing the Store key, the scene will be saved on the manual cue
controlled by the slider moved.
The Flash/Release channel works in the following way:
• Reaching 100% is equivalent to bring the manual cue slider at 100%
• When the channel value goes down to 0% a release command is sent.
IMPORTANT: if you enable the manual cues remote control by DMX, all the controllers congurated as
manual cues are changed in playbacks masters and the control of all manual cues is moved to the extern
DMX device.