DG-GS1528HP User Manual
3. Getting Started
This section provides an introduction to the web-based configuration utility, and
covers the following topics:
•
Powering on the device
•
Connecting to the network
•
Power over Ethernet (PoE) considerations
•
Starting the web-based configuration utility
3.1. Power
3.1.1. Connecting to Power
Power down and disconnect the power cord before servicing or wiring a
switch.
Do not disconnect modules or cabling unless the power is first switched off.
The device only supports the voltage outlined in the type plate. Do not use
any other power components except those specifically designated for the
switch.
Disconnect the power cord before installation or cable wiring.
The switch is powered by the AC 100-240 V 50/60Hz internal high-performance power
To Next Page
Loading...
Need help?
General
