21
160XT 180XT 210XT
7 WORKSITE INSPECTION
1. General information
- Is the lift suited for the intended job?
- Is the performance of the lift sufficient for the job? (reach, loadability etc.)
- Is the position of the lift safe?
- Is the lighting on the worksite sufficient?
2. Documents
- Are the Operation and Service Instructions for this lift present? (Manufacturer´s
instructions)
- Are inspections and servicing carried out in accordance with the instructions and
have the defects affecting the safety been checked as repaired?
(Inspection protocols)
3. Structure (Visual inspection and operational test)
- General condition of the lift
- Operation and protection of the controls
- Emergency stop, signal horn and limit switches
- Electrical appliances and wiring
- Oil leaks
- Load markings and signs
4. Operator
- Is the operator old enough?
- Has the operator received the required training?
5. Special issues on the worksite
- Are there any additional regulations relevant to the worksite or the work?
Courtesy of Crane.Market
To Next Page
Loading...
