78
160XT 180XT 210XT
- inspect the turning device
- general condition
- check the play and attachment of the angular gear
- check the condition of the gear ring
- check the play of the turning gear
- check the tightening torque of the turning bearing´s attachment screws
(M16 280 Nm, M12 150 Nm)
- check the attachment of the turning motor
- check the condition of the chassis
- general condition
- check the attachment of the tow-bar to the chassis
- check the condition of the overrun and its attachment to the chassis.
- check the axle and its attachment to the chassis
- check the attachment and condition of the brake wires and rods
- check the rims, the tightness of the wheel bolts, the tyres and the tyre
pressure
- check the condition of the driving device, attachment of the parts and
condition of the covers for electric components
- check the condition of the transport support of the boom
- perform a test run, test all the operating controls, control the outreach in accordance
with the instructions
(See point “Inspection and adjustment of the overload limit switches”)
- also check the operation of the limit switches during the test run (refer to the service
instructions)
- the load-sensing limit switches on the safety devices
- the limit switches on the outriggers, which prevent the operation of the
boom movements
- the limit switches on the tow-bar, which prevent the use of the outriggers
- after the test-loading and test drive make sure that the steel structures or other loaded
parts do not show signs of structural defects, such as fractures or dangerous
permanent deformations
- draw up a protocol of the regular inspection with following articles:
1. inspection form
2. data of repair welds
a) date of repair
b) repaired by whom
c) what was repaired
- when the machine is ready for operation after the annual inspection, mark the
inspection date on the inspection plate affixed to the lift
20.5 EXTRAORDINARY INSPECTION
(INSPECTION AFTER AN EXCEPTIONAL SITUATION)
The inspection is required if the lift has been damaged in a manner which may
affect its strength or safe operation.
Courtesy of Crane.Market
To Next Page
Loading...
