50
160XT 180XT 210XT
19 INSTRUCTIONS FOR SERVICE AND MAINTENANCE
19.1 GENERAL SERVICE INSTRUCTIONS
- carry out the servicing and inspection of the lift in accordance with the instructions
- in case of more demanding repair works, turn to a specialist or contact the
distributor or the manufacturer of the lift
- do not modify the lift without written consent from the manufacturer
- any such faults which may affect the operational safety of the unit must be
repaired before the lift is next used
- do not let oil spill on the ground
- keep the lift clean, especially the platform
- clean up the lift before service and inspection
- use genuine spare parts
- support the platform, boom system, articulated arms and support outriggers in a
position in which the load does not rest on the structure under repair or cause any
other danger (e.g. transport position or use of supporting structures)
- the device may be lifted with two slings, each with a load-carrying capacity of at
least 2,500 kg, by slinging it at the four lugs (see picture)
Be careful not to damage the device during the lifting operation.
160XT = 185 mm
180XT = 230 mm
210XT = 250 mm
Courtesy of Crane.Market
To Next Page
Loading...
