Dinolift 160XT - Service and Inspection Instructions

51
160XT 180XT 210XT
19.2 SERVICE AND INSPECTION INSTRUCTIONS
1. The first service after 20 hours of operation
- change the pressure filter element
- adjust the brakes according to the instructions (see point “Wheel brakes and
bearings”)
- check the wheel bolts for tightness (160XT = 90 Nm/180XT and 210XT = 325
Nm) after about 100 km of driving
2. Daily service
- check the oil level in the hydraulics, top up if necessary
- check the hydraulic connections
- check the structures visually
- check the operation of the emergency descent and emergency stop functions
- check the operation of the safety devices
3. Weekly service
- check the tyre pressure (450 kPa, jockey wheel 250 kPa)
- lubricate the joint pins (see point “Lubrication plan”)
- check the sliding surfaces of the telescope and lubricate them with silicon, if
necessary
- check the clearance between the slide pads and surfaces and adjust the pads
if necessary
- put a load (160XT = 270 kg/180XT = 120 kg/210XT = 80 kg) onto the platform
and drive the boom to a horizontal position
After this, extend the telescope until the red signal light lights up and the
movement stops. Measure the stroke in accordance with the instructions, and
compare it with the setting of the RK4 (see point “Adjusting the overload limit
switches”). If the stroke is longer, contact the service technician.
4. Service every six months
- change the hydraulic oil and the filter cartridge.
- check the condition of the brakes
- check the the wheel bolts for tightness (160XT = 90 Nm/180XT and 210XT =
325 Nm)
- grease the gear ring of the turning device
5. Periodic service every 12 months in accordance with the instructions for
regular servicing below in this manual
If the lift is operated under demanding conditions (in
exceptionally humid or dusty environment, corrosive
climate, etc.) the intervals between the oil changes and
the other inspections shall be shortened to meet the prevailing
conditions in order to maintain the operational safety and reliability of
the lift.
The performance of the periodic servicing and the inspections is
absolutely mandatory, because their negligence may impair the
operational safety of the lift.
The guarantee will not remain valid, if the servicing and the periodic
inspections are not performed.
Courtesy of Crane.Market