71
160XT 180XT 210XT
Wheel bolts:
160XT = 90 Nm
180XT and 210XT = 325 Nm
On the rear axle: 270 kPa (2.7 bar)
On the tow-bar jockey wheel: 250 kPa (2.5
Test load:
160XT = 270 kg
180XT = 120 kg
210XT = 80 kg
13. Warning stickers and adhesive tapes
- make sure that all the warning stickers and adhesive tapes are legible, replace if
necessary
14. Inspect the brakes and the driving device
- remove the wheels
- clean the brake system and check the settings
- check that the brake shoes can move, and that their springs properly return them
- replace any worn out linings
- check the condition of the driving device and lubricate the joints
- put the wheels in place and tighten the wheel bolts
Remember to re-check the tightness of the wheel
bolts after a drive of about 100 km.
- check the tyre pressure:
- check the free movement of the overrun brake and the parking brake
- check the safety wires
15. Traffic lighting
- check the condition of the lights and the reflectors
16. Anti-corrosion treatment
- repeat the anti-corrosion treatment using e.g. Tectyl 210R anti-corrosion agent
17. Test-run
- perform a test-run with a load defined in the loading
instructions.
Check the structures after the test-run.
18. TEST PROTOCOL
- draw up a test protocol, save your own copy, and give the other copy to the customer
Courtesy of Crane.Market
To Next Page
Loading...
