DWG2000E/F/G GSM/CDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Technologies Co., Ltd.
77
5. Troubleshooting and Command Line
5.1 Login DWG & General Knowledge of DWG Command
This is a document for some customers who need more details of DINSTAR’s products with
command lines. To make sure the system runs successfully, we suggest customers setting
DWG by GUI. In this manual, some topics such as how to check the IP, signaling and call
conversation are covered.
Tips: The document is fit for all DWG2000E/F/G models.
Run system tool Telnet to login DWG. The default username and password is "admin".
C:\Users\Administrator>telnet 172.16.101.142
Input "?" to show the all commands and its information.
Abbreviation is supported in DWG command. For example you can input "en" substitute for
"enable", input "sh" substitute for "show", input "cl" substitute for "clock",
5.2. Commands in "ROS#" Mode
There is only a litter commans in "ROS>" mode. If you need more commands you must enter
the "ROS#" mode. Input "enable" to enter "ROS#" mode if you have in the "ROS>" mode.
5.2.1 Summarize of commands in "ROS#" mode
Input "?" to get the information of all commands in "ROS#" mode.
To Next Page
Loading...
