Dinstar DWG2000E - 1.4 Functions and Features; 1.4.1 Supported Protocols; 1.4.2 System Functionality

DWG2000E/F/G GSM/CDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Technologies Co., Ltd.
7
2
Antenna Connector
Mark as digits 0 to 7
3
Network
FE0 and FE1, its default IP address 192.168.11.1
4
Console
RS232 standard, band rate 115200bps
5
RST
Reset button to restore default IP and password or restore
factory setting.
 Restore IP and Password: hold RST button 3~5 seconds,
RUN LED being ON during this time
 Restore factory setting: Hold RST button 7 seconds,
RUN LED being blink
The appearance of DWG2000F
The appearance of DWG2000G
1.4 Functions and Features
1.4.1 Protocols
 Standard SIP;
 Simple Traversal of UDP over NATs (STUN);
 Point-to-point protocol over Ethernet (PPPoE);
 Hypertext Transfer Protocol (HTTP);
 Dynamic Host Configuration Protocol (DHCP);
 Domain Name System (DNS);
 ITU-T G.711α-Law/μ-Law、G.723.1、G.729AB;
 PPTP available on DWG2000E
1.4.2 System Function
 PLC: Packet loss concealment