Page 90
Chapter 4
Installation Instructions
19. You are now ready to verify reception from both satellites. Select the
Check Switch option.When the Check Switch menu opens, select
Check or Test. The receiver shows you a message that it is checking
the switches. When the procedure is finished, you will see an
Installation Summary screen. This screen may look different than the
one shown below. However, you must see that you have signals from
both the
110 West and 119 West Satellites, you see “All” twice in the
Transponder line, and the message “Satellite reception verified.
Select CANCEL or OK to exit this menu.”
20. If you do not see “110” under
Dish Input 2:
• Make sure the skew angle you wrote down on page 84 is exactly
the same as the skew angle you set in step 5 on page 86. If it is
not, reset the skew angle as described on page 86. After you reset
the skew angle, go back to page 89 and start over from step 16.
• If “119” is shown under
Dish Input 2, move the dish
approximately 9º to the east and restart the procedure at step 12.
21. Look at the
Point Dish/Signal menu. If you have good signal strength
with the check mark in
119 West, move the check mark to 110 West.
If you have good signal strength on
110 West, go to the next step.
If you do not have good signal strength with the check mark in
110
West
, go back to Step 17, and fine-tune the dish but with the check
mark in
110 West instead of 119 West. While the 110 West and 119
West signals will not be equal, you should be able to fine-tune the
dish until you have the strongest possible signal from both satellites.
22. Select CANCEL to exit the
Point Dish/Signal menu. An Attention
screen will open asking if the mounting and positioning of your dish is
complete with a “Locked” indication in the Point Dish/Signals screen.
If the answer is yes, select
Yes.
If the answer is
No, you will need to repoint your dish following the
preceding step until the mounting and positioning is complete and you
do have the “Locked” indication.
To Next Page
Loading...
