Dish Network 500 - Page 97

lPage 93
Page 93
Installing a DISH 500 Antenna
10. Press CANCEL to exit back to the Point Dish/Signal menu.
11. Point the dish for the strongest possible signal, following the instructions
that came with it and the DishPro wiring diagrams that start on page 94.
12. Connect any switches in your system, using the instructions which came
with the switch(es).
13. Select
Check Switch from the Point Dish/Signal menu. When the
Check Switch menu opens, select Check or Test. When the procedure
completes, you will see the
Installation Summary screen again.This time
you should confirmation for all satellites your dish is pointed at, and
“Satellite reception verified.” You should also see that the switch(es) in
your system has been correctly identified.
Refer to the DishPro wiring diagrams for examples of installation
summary screens.
14. Press
CANCEL to exit this menu, and then Cancel to exit the Point
Dish/Signal
screen.
If you have any other receivers in your system, make sure you run
Check
Switch
on each of them, and allow each to take the software upgrade, as
needed.