EasyManua.ls Logo

Dodge D350 1990 - Rear Crankshaft Seal; Rear Gear

Dodge D350 1990
482 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Base
Engine
Components
DODGE
Turbo Diesel
In-Chassis
Diagnostic Procedures
Page
9E-7
Ring
Gear
Occasional
failure of a starter to engage can be caused by
damaged
teeth
on the ring gear. Service ring gears are
available for repairing flywheels.
If a ring gear is damaged on an automatic
transmission
drive
plate, the drive
plate
must be replaced.
Rear
Crankshaft Seal
The rear crankshaft seal is mounted In a housing
that
bolts to
the rear of the block. Double-lipped Teflon
seals
are
used.
The
Sealing
surface on the crankshaft must be clean, dry and
free
of oil during installation of the
seal.
Caution:
if any oil gets on the crank surface or seal
during Installation, the seal
will
leak.

Table of Contents

Related product manuals