Dodge D350 1990 - Rocker Lever Assembly Installation

Base Engine Components
DODGE Turbo Diesef
In-Chassis Repairs
PageiF-7
Rocker Lever Assembly-installation
Caution: Make sure the dowel rings in the pedestals are
installed into the dowel bores in the cylinder head. • •
Note: If the push rod is holding the pedestal off of the cylinder
head, bar the engine until the pedestal will set on the head
surface without interference.
Use clean engine oil to lubricate the threads and under the
heads of the 8mm and 12mm capscrews.
Install the capscrews into the pedestals.