Dodge D350 1990 - Flywheel - Installation

In-Chassis Repairs
Page 9F-48
Base Engine Components
DODGE Turbo Diesel
Heat the new ring gear for 20 minutes In an oven preheated to
127°C [250°F].
Warning: Wear protective gloves when you install the
heated gear.
*
v
Install the gear. The gear must be installed so the bevel on the
teeth is towards the crankshaft side of the flywheel.
Flywheel - Installation
Caution: Never use the timing pin to hold the crankshaft in
position.
Use the engine barring tool to hold the crankshaft when the
flywheel capscrews are being tightened.
1^ 10mm Socket, Torque Wrench
(f^j Tighten the capscrews in the sequence shown.
Torque Value: 137 N-m [101 ft-lbs]