Power Steering and Vacuum Pump
Page 5-6
Service
Brakes
DODGE
Turbo Diesel
Clean
parts in hot water and detergent or use a solvent and
blow dry
with
compressed air.
Reassembly
Install the two spacers on the studs on the power steering
pump.
Install the gear/eccentric/bearing assembly by pulling it onto
the power steering shaft
with
a 3/8 inch 18 thread capscrew
with
a
flat
washer threaded
into
the power steering pump shaft.
Pull it on
until
it bottoms.
Caution: This is a press fit and
will
require a minimum of
SAE
Grade 8
capscrew
for thread strength.
Remove capscrew and washer
after
pulling eccentric on to the
shaft.
To Next Page
Loading...
