Dodge D350 1990 - Exhaust System and Intake Manifold Specifications

Exhaust System and Intake Manifold
DODGETurbo Diesei
Specifications
Page 11-37
Specifications
Torque Values;
Air Crossover to Intake Manifold Capscrews 24 N-m [18 ft-lbs]
Turbocharger Air Crossover Hose Clamps 5 N-m [44 in-lbs]
Intake Manifold Cover Capscrews 24 N-m [18 ft-lbs]
Fuel Heater Ground Capscrew 12 N-m [110 in-lbs]
injector Fuel Nut 24 N-m [18 ft-lbs]
Turbocharger Exhaust Manifold Nuts 32 N-m [24 ft-lbs]
Turbocharger Drain Line Connection Capscrews 24 N-m [18 ft-lbs]
Turbocharger Oil Supply Line Fitting 15 N-m [11 ft-lbs]
Exhaust Manifold Capscrews 43 N-m [32 ft-lbs]
Throttle Control Bracket Mounting Capscrews 24 N-m [18 ft-lbs]
Turbocharger Impeller Nut 14 N-m [129 in-lbs]
Turbocharger Bearing Housing to Turbine Housing Capscrews 11.3 N*m [100 in-lbs]
Turbocharger Bearing Housing to Diffuser Capscrews 5.7 N-m [50 in-lbs]
Turbocharger V-Band Clamp 8 N-m [72 in-lbs]
Dimensions / Clearances:
Turbocharger Rotor Assembly End Play
Turbocharger Radial Clearance
Turbocharger Shaft Bearing Diameter .
0.026 - 0.076 mm [0.001 - 0.003 inch]
0.30 - 0.46 mm [0.012 - 0.018 inch]
10.97 mm [0.432 inch]
Air Intake Restriction
635 mm H
2
0 [25 inches H
2
0] maximum