Base
Engine Components
DODGE
Turbo Diesel
In-Chassis
Repairs
PageiF-39
If the camshaft is not to be used immediately, lubricate the
lobes and journals to prevent rusting.
Camshaft Bushing - Inspection
Caution: If the camshaft bore for the first cam bushing is
worn beyond the
limit,
install a new service bushing. • •
Inspect the rest of the camshaft bores for damage or
excessive
wear.
Measure the diameter of each bore. (The
limit
for the bushing in
the No. 1 bore is the same as for the other bores
without
bushings.)
Limit
Inside Diameter:
54.133mm
[2.1312
inch]
Note:
If the bores
without
a bushing are worn beyond the
limit,
the engine must be removed for machining and installation of
service
bushings or replacement of the cylinder block.
Remove the bushing
from
the
Number
1
bore, using a universal
cam bushing tool.
Note:
Mark
the cylinder block so you can align the oil hole in
the cylinder block
with
the oil hole in the bushing.
To Next Page
Loading...
