Base
Engine Components
DODGE
Turbo Diesel
In-Chassis
Repairs
Page 9F-29
Tighten the adjusting
screw
for the exhaust valve two complete
turns of the
screw.
Tighten the locknut.
Caution: Use extreme care
that
the piston does not
against the exhaust valve
with
so much force
that
it t
the push rod.
Rotate the crankshaft slowly in the direction of engine re
until
the piston touches the exhaust valve.
Mark
the vibration damper corresponding to the wire poin
Measure the distance and
mark
the pulley at one-half the n5n
distance between the two marks. This
mark
is
the TDC mark. >!Ls
To Next Page
Loading...
