Base
Engine Components
DODGE
Turbo Diesei
In-Chassis
Repairs
Page9F-41
Make
sure the trough is positioned so it will catch the tappet
when the wooden dowel is removed.
Note:
Identify
the location of each tappet as it is removed. The
tappets must be installed in their original locations.
Only remove one tappet at a time. Remove the rubber band
from
the two companion tappets,
securing
the tappet not to be
removed
with
the rubber band.
Pull
the wooden dowel
from
the tappet bore allowing the tappet
to fall into the trough.
Normally the tappet will fall over when it drops into the trough.
Use
a flashlight to determine this. If the tappet does not fall
over,
shake
the trough gently to get it to do so.
To Next Page