In-Chassis
Repairs
Page9F-50
Base
Engine Components
DODGE
Turbo Diesel
Install the seal
pilot,
provided in the replacement kit, on the
crankshaft.
Push
the
seal
on the
pilot
and crankshaft.
Remove the
seal
pilot.
Note:
Seal O.D. lubricant/sealant:
>
Rubber O.D. rear crandshaft
seals
are lubricated with-
soapy
water.
-
Seals
without
rubber O.D. use Loctite
277,11264
or no.
2654422
sealant.
Use
the alignment
tool
to install the
seal
to the correct depth in
the housing. Use a hammer to drive the seal
into
the housing
until
the alignment tod stops against the housing.
Hit the
tool
at the 12, 3, 6 and 9 o'clock positions to drive the
seal
evenly and prevent bending the
seal
housing.
To Next Page