Base
Engine Components
DODGETurbo Diesel
Out-of-Chassis
Repairs
Page 91-15
Note:
Vertical strikes must be smooth continuous
along the
full
length of the bore.
Inspect the bore
after
10 strokes.
Use
a strong solution of hot water and laundry detergent to L\
clean
the bores.
Since
a large volume of water must be used to rinse the bores,
position the block over or
close
to a floor drain.
Caution: Clean the cylinder bores Immediately
after
de-
glazlng.
Rinse
the bores
until
the detergent is removed and blow the
block dry
with
compressed
air.
Caution: Be sure to remove the tape covering the lube
holes
after
the cleaning process is complete.
Check
the bore cleanliness by wiping
with
a white,
lint
free,
lightly
oiled cloth. If
grit
residue is still present, repeat the
cleaning process
until
all residue is removed. Wash the bores
and the complete block assembly
with
solvent and dry
with
compressed
air.
To Next Page
Loading...
