Dormakaba ES 250 PRO - Page 76

76
WN 059677 45532 - 11/2023
ES 250 PRO/ES 250 PRO FST
ES 400 PRO/ES 400 PRO FST
Mounting instructions
Display Meaning/cause Troubleshooting/possible causes
E069 Firmware update
Install firmware via Operator Service Interface Replace control unit if necessary
E071 EEProm memory check failed
Select factory setting Replace control unit if necessary
E072 Second shutdown path CPU 1
Replace control unit
E073 Second shutdown path CPU 2 (ES250/400 PRO FST only)
E074 Watchdog CPU 1
E075 Watchdog CPU 2 (ES250/400 PRO FST only)
E080 Charge battery
Checking the setting for battery operation Is the battery connected correctly? Is the battery sufficiently charged? Measure battery voltage Check wiring Replace battery if necessary
E081 Battery undervoltage
Check wiring Charge battery Replace battery if necessary
E082 Battery overvoltage
Check battery charging voltage Replace control unit if necessary
E083
Battery test run failed (ES250/400 PRO FST only)
Check battery Replace battery if necessary
E084 Battery charging circuit Replace control unit if necessary
E085 Battery missing
Check battery Check wiring Replace battery if necessary