DSE Model 5510 Autostart Control and Instrumentation System Operators Manual
057-015 5510 OPERATING MANUAL ISSUE 11 07/07/09 AM 77
16.7 SYNCHRONISING NOTES
Optionally, the 5510 controller can be configured to forward synchronise, volts match and parallel
with the mains supply. This facility can be used to supply a fixed amount of power to the load and/or
mains supply or share load with other 5510 or 550 enabled generator systems.
16.7.1 CHECK SYNC
(If enabled)
The module will control the operation of the load-switching device to allow parallel operation with the
mains / bus supply only when the two supplies are in synchronism.
16.7.2 AUTO SYNC
(If enabled)
The module provides control signals to the Engine Governor and the Alternator AVR to control the
speed and voltage output from the generating set.
Refer to the 5xxx software manual for further details.
16.7.3 LOAD CONTROL
(If enabled)
The module features all the functions associated with the Check sync and auto sync features and in
addition, it provides control signals to the Engine Governor and the Alternator AVR while in parallel
with the mains (utility) or generator bus.
These functions can be used to provide peak shaving and load sharing with other 5510 enabled
generating set systems.
Refer to the 5xxx software manual for further details.
To Next Page
Loading...
Need help?
General
