DTG M Series Maintenance Manual Printing on Textiles
4.7.2 Cancelling the Print Job
It may be best to cancel the print job and start again. As with any inkjet printer, it is sometimes
difficult to stop a print job with the DTG M2™ once you have set it in motion.
Firstly, press the Emergency Stop button on the front of the printer – this will immediately cut 1.
power to the printer & stop the print job.
Press the [Power] key to return the Control Panel to an “off” state. 2.
Open the Top Cover of the printer and gently slide the Carriage Assembly to the right until it 3.
“clicks” into it’s home position on the Capping Station.
Cancel / clear the print job from the RIP and / or the Windows Print Queue. 4.
Do not allow the Carriage assembly to remain out of the capping station for longer than two or
three minutes. Failure to do so will result in possible blockage of print nozzles due to ink drying.
This may result in irreversible damage to the print head requiring print head replacement.
4.7.3 Re-starting the Printer after Cancelling a Print Job
Re-start the printer by following the steps shown at 3.5.1 "Switching the Printer ON" p.29
To Next Page
Loading...