Initial Setup & Basic Operations DTG M Series Maintenance Manual
3.1 Introduction
This chapter provides information on the initial setup and basic operation of the M2 Printer.
It is highly recommended that the initial setup of the printer be performed by a DTG trained &
authorized technician. Damage caused by incorrect setup will not be warrantied.
Initial setup should be undertaken in the following order:
1. Position the printer – refer to 3.3 "Choosing a Place for the Printer" p.25
2. Remove packaging materials 3.6.1 "Removal of Shipping Tape" p.43
3. Load colour inks (before power is applied to the printer) 3.6.2 "Initial Ink Fill Process -
Colours" p.44
4. Load white ink 3.6.3 "Initial Ink Fill Process – White" p.47
5. Load media for printing 3.6.4 "Loading Media for Printing" p.49
3.2 Before you Get Started
3.2.1 Commit to Maintenance
Your DTG M2™ represents a significant investment, not only of your money but also of your
commitment to your new business opportunity with the DTG M2™.
Whilst the mechanics of the printing unit of the M2 are similar to that of a normal inkjet printer,
printing on fabric is not the same as printing on paper. Fabric generates much more dust, printing
on fabrics requires a much greater volume of ink, and the white ink pre-treatment can become
airborne during spraying and can ingress into the M2. Each of these factors individually can cause
problems with your DTG M2™, and in combination can be critical to the ongoing operation of the
M2. All is not lost, however! A few minutes of your time each day spent undertaking some basic
maintenance tasks on the M2 will ensure it’s continued optimal performance. Please refer to the
sections within this User’s Guide on Preventative Maintenance for further information.
3.2.2 Get to Know your M2
Starting a new business or adding to your existing product line with the DTG M2™ is a very exciting,
and potentially very profitable time. Don’t get too carried away though and start accepting orders
before you even have your printer. Allow plenty of time to become familiar with your M2 and to
learn not only the basics, but also the variables that can impact on your finished product. These
variables include image types, fabric types, your operating environment, garment preparation, and
curing of the garment. Thoroughly read this manual, ask questions of your DTG Technician or
Distributor, talk to other users (see various internet forums). Be prepared to ruin a few shirts. Be
realistic about deadlines when accepting orders and allow yourself sufficient time (and perhaps a
couple of extra garments) to complete the order.
To Next Page
Loading...