DTG M Series Maintenance Manual Product Overview
1.3 Important Safety Instructions
General safety instructions that must be observed to use the equipment safely are explained below.
Do not place the printer in the following areas. Doing so may result in the printer tipping or 1.
falling over and causing serious injury.
Unstable or loose surfaces
Angled surfaces
Areas subject to vibration by other equipment
Do not stand on or place heavy objects on your printer. Doing so may result in the printer 2.
tipping or falling over and causing injury.
Do not cover the ventilation hole of your printer with cloth, such as a blanket or table cloth. Doing 3.
so could obstruct ventilation and cause fire.
Do not place the printer in humid and dusty areas. Doing so may result in electrical shock or fire. 4.
Make sure to use the power cable packed with the printer you purchased. Not doing so may 5.
result in electrical shock or fire.
Do not use the power cable if it is damaged in any way. Doing so may result in electrical shock 6.
or fire.
Do not insert or drop metal or objects which are easily combustible through the openings such 7.
as the ventilation hole of your printer. Doing so may result in electrical shock or fire.
Do not operate the printer if it has been contaminated by foreign substances or liquid spills as 8.
doing so may result in electrical shock or fire. Immediately turn off the power switch,
disconnect the power plug from the electric socket, and contact your authorized DTG Dealer.
Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240 V). If the 9.
power supply other than the specified voltage is used, it could cause an electric shock and fire.
Take power for the plotter directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 10.
V). Do not use complex multiple plugs on the same socket. This could generate heat and might
cause fire.
Make sure that the following is performed before parts replacement. 11.
Turn off the power of the printer.
Remove the power cable from the power outlet. Not doing so may cause electric shock or
damage to the electric circuit.
Unplug the cables connected to the printer. Failure to do so could result in damage to the
printer.
To Next Page
Loading...