DTG Digital DTG M2 - Printer Installation Requirements

25
DTG M Series Maintenance Manual Initial Setup & Basic Operations
3.3 Choosing a Place for the Printer
 Do not place the printer in a location under the following conditions. Doing so may cause
the product to fall over, become damaged, or cause serious injury:
o Unstable or shaky surfaces.
o Slippery, slanted or angled surfaces.
o Locations that are subject to vibration from other products.
 Do not stand, or lean, on the printer or place any objects on it. Doing so may cause it to fall
over, become damaged, or cause injury.
 Do not cover any ventilation holes or slots of the printer with anything at all. Doing so could
prevent the printer from ventilating and cause fire.
 Keep the printer away from damp, humid or dusty areas. Failure to do so may result in
electrical shock or fire.
3.3.1 Installation Environment Requirements
Choose a place for printer installation following the requirements of the table below.
Installation space
5m
2
or more, 2.6m or more is required for the width
Floor loading capability
Up to 3000Pa (450kgf/m
2
) or more
Electrical
specifications
Voltage
AC 100 V - 120 V ± 10% or AC 200 V - 240 V ± 10% (auto-
switching)
Frequency
50/60Hz ± 1Hz
Capacity
Up to 4A or more
Environmental conditions
Temperature
Humidity
Operation environment
18º C (64F) to 30ºC
(86F)
20% to 80%, with no
condensation
Printing accuracy warranty range
18ºC (64F) to 28ºC
(82.4F)
40% to 60%, with no
condensation
Rate of change
2ºC per hour or less
5% per hour or less
TABLE 3-1 INSTALLATION ENVIRONMENT REQUIREMENTS
WARNING