Initial Setup & Basic Operations DTG M Series Maintenance Manual
Avoid the following temperature and humidity conditions. Otherwise, printed images may appear
differently from what you expect and machine operation may be erratic or incorrect.
Places where sudden changes in temperature or humidity are expected, even if the condition
is within the range specified within this document.
Places where direct sunlight or excessive lighting conditions are expected
Places where air conditioners blow directly.
Impression Technology strongly recommends that the printer should be installed where air
conditioning airflow, humidity and temperature can be adjusted easily.
3.3.2 Required Space
Install the printer on a flat surface that meets the following conditions:
The load bearing surface will fully support the full weight of the printer (and/or stand) plus
100%.
The load bearing surface has an angular difference from level by no more than 2 degrees.
The load bearing surface is textured and firm enough to be considered a non-slip, hard
surface.
The load bearing surface will fully support lateral forces in all directions in excess of 100kg.
For printer options 7.3 "Options/Supplies List" p.157
To Next Page
Loading...