DTG Digital DTG M2 - Handling the Warning Labels

6
Product Overview DTG M Series Maintenance Manual
1.4 Warning Label types and meanings
The handling, attachment locations, and types of warning labels are explained below.
Warning labels are attached to areas where care should be taken. Read and understand the
positions and contents thoroughly before maintenance operation.
1.4.1 Handling the Warning Labels
Make sure to note the following when handling the warning labels.
Make sure that all warning labels can be recognized. If text or illustrations cannot be seen 1.
clearly, clean or replace the label.
When cleaning warning labels, use a cloth with water or neutral detergent. Do not use any 2.
solvent or gasoline products.
If a warning label is damaged, lost, or cannot be recognized, replace the label. 3.
Ref
Warning Label Type
A
Using this area as a lift point will cause damage to the printer.
B
Do not touch anything in this area unless instructed.
C
Dangerous voltages present in this area.
D
Fingers may be trapped and ripped off in this area.
TABLE 1-2 WARNING LABEL TYPE
A
B
C
D
NOTE