DTG Digital DTG M2 - Errors with Message

120
Troubleshooting DTG M Series Maintenance Manual
6.2.2 Errors with Message
This section describes the contents of errors with messages as well as the check items and recovery
actions. These messages are displayed when an abnormal condition occurs while the machine is
running.
Upon an occurrence of an error with message, the machine stops its operation at the same time.
In some instances, the error may be cancelled by removing the error causes. After that, the machine
will restart its operation.
TABLE 6-3 SYMPTOMS AND CHECK ITEMS FOR ERRORS WITH MESSAGE
No.
Message
Event/
Symptom
Check item
Action
Reference
1
Media
detection
error
-
1. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again
and check if the
same message
appears.
If the message
appears: Contact
your authorized DTG
Distributor or
Technician for
further assistance
3.5.2
"Switching
the Printer
OFF." p.31
3.5.1
"Switching
the Printer
ON" p.29
2
Media skew
error
Media skew
error is
displayed
1. Wrong settings in
panel control.
Check settings .
3.5.4
"Confirming
Default
Settings"
p.34
2. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again
and check if the
same message
appears.
If the message
appears: Contact
your authorized DTG
Distributor or
Technician for
further assistance
3.5.2
"Switching
the Printer
OFF." p.31
3.5.1
"Switching
the Printer
ON" p.29
3
Warning:
Waste fluid
box full
Automatic
Waste fluid
reset failed.
1. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again
and check if the
same message
appears.
If the message
appears: Contact
your authorized DTG
Distributor or
Technician for
further assistance
3.5.2
"Switching
the Printer
OFF." p.31
3.5.1
"Switching
the Printer
ON" p.29