Initial Setup & Basic Operations DTG M Series Maintenance Manual
3.6.2 Initial Ink Fill Process - Colours
The syringe & tube adapter kit (from maintenance kit supplied with M series printers) are
required for this procedure. Use protective gloves to avoid stained fingers.
1. Ensure that all tube clamps are in the open position as shown, wheel at the wide end.
2. Unscrew the lids on each of the four colour ink containers and ensure they are empty.
There may be a small quantity of shipping fluid inside which will need to be poured out.
3. Fill each container with DTG ink to just below the curve at the top of each container as
shown.
To Next Page
Loading...