Product Overview DTG M Series Maintenance Manual
Pay attention to the following when handling the power cable: 1.
Do not do anything forcefully (e.g. pull, bend, twist) on the power cable
Do not place heavy objects on the power cable
Do not route the power cable near heat sources
Pay attention to the following points while handling the power supply plug. Not going so may 2.
result in electrical shock or fire:
Make sure that the power cable / plug is not contaminated by no foreign substances such as
dust etc.
Make sure that the power plug is correctly connected to the power socket.
Pay attention when handling inks so that ink does not get into the eyes or spill on your skin. If 3.
the ink does get into eyes or onto skin, immediately wash the affected area with water. The
inks may cause mild skin irritation and/or inflammation of the eyes. Consult with medical
personnel in the case of any severe reaction.
Be careful to ensure that fingers are not caught in the opening when lifting and closing the top 4.
cover of the printer.
Do not use strong solvents such as thinners, benzene or alcohol on the printer. These products 5.
may damage the paint on the printer.
Take care that moisture does not enter the printer. There is a risk of a short circuit of the 6.
electrical circuit(s) within the printer if this occurs.
Ensure that the printer is always kept in a horizontal position, even whilst it is being lifted or 7.
moved.
Do not leave the printer on a slanted surface. Do not leave the printer upside down. Doing so 8.
may cause ink leakage and / or trouble that cannot be restored, as the printer is originally
assembled in the factory with a high accuracy of 1/100 mm.
Ensure all packing materials are removed from the printer before lifting from it’s crate. If the 9.
printer is lifted with materials attached, it may slip from the hands and be damaged.
Assembling and disassembling of the printer are possible only for the parts that disassembling 10.
procedures are shown in this manual, and should be undertaken only by DTG authorized and
trained professionals. Do not disassemble any frame parts or parts that disassembling
procedures are not shown in this manual. Doing so may cause trouble that cannot be restored,
as the printer is originally assembled in the factory with a high accuracy of 1/100 mm.
Do not touch the elements on the circuit board with bare hands. Doing so may cause static 11.
electricity and cause catastrophic invisible damage.
Do not press the transparent film on the damper assembly with your hands. Doing so may 12.
discharge the ink filled inside the damper assembly or damage the pressure valve.
Be careful not to damage the transparent film on the damper assembly. 13.
Do not touch the nozzle plate of the print head, keep free from dust. 14.
There is ink in the tubes throughout the printer. Be careful that the ink is not spilled from any 15.
tube outlet onto the printer or items close to the printer.
To Next Page
Loading...