DTG Digital DTG M2 - Page 151

27
DTG M Series Maintenance Manual Troubleshooting
TABLE 6-8 CHECK ITEMS AND ACTIONS FOR INITIAL OPERATION PROBLEMS
No.
Symptom
Check Item
Action
Reference
8
After turned ON,
machine displays
“initializing” and
resets itself
1. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again and
check if symptom is
repeated.
If the symptom is
repeated: Contact your
authorized DTG
Distributor or Technician
for further assistance
3.5.2
"Switching the
Printer OFF."
p.31
3.5.1
"Switching the
Printer ON" p.29
9
Machine does not
perform
initialization.
1. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again and
check if symptom is
repeated.
If the symptom is
repeated: Contact your
authorized DTG
Distributor or Technician
for further assistance
3.5.2
"Switching the
Printer OFF."
p.31
3.5.1
"Switching the
Printer ON" p.29
10
Machine does not
stop.
1. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again and
check if symptom is
repeated.
If the symptom is
repeated: Contact your
authorized DTG
Distributor or Technician
for further assistance
3.5.2
"Switching the
Printer OFF."
p.31
3.5.1
"Switching the
Printer ON" p.29
11
Operation panel
accepts no inputs
1. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again and
check if symptom is
repeated.
If the symptom is
repeated: Contact your
authorized DTG
Distributor or Technician
for further assistance
3.5.2
"Switching the
Printer OFF."
p.31
3.5.1
"Switching the
Printer ON" p.29
12
Machine prints
nothing though it
receives data
2. Turn machine OFF.
Disconnect mains
power, wait 5
minutes.
Turn it ON again and
check if symptom is
repeated.
If the symptom is
repeated: Contact your
authorized DTG
Distributor or Technician
for further assistance
3.5.2
"Switching the
Printer OFF."
p.31
3.5.1
"Switching the
Printer ON" p.29