DTG M Series Maintenance Manual Initial Setup & Basic Operations
3.5.3.2 Connecting USB interface cable
Install the printer driver 3.6.9 "Installing & Using Printer Drivers" p.66 before connecting the
USB cable
Insert the USB cable into the USB connector on the back of the plotter. 4.
Connect the other USB cable connector to your PC. 5.
Refer to the Operation Manual of your PC for the connection to your PC
USB connection supports Windows 98 and higher
This printer supports USB 2.0. If the connection is made under the following conditions,
the speed may decrease to the level measure ins USB1.1
o When the USB connection is used in Windows 98
o When your PC does not support USB 2.0
o When a USB hub of not USB 2.0 type is used
When using the printer with USB connection, install the printer driver into your PC
using the printer driver provided with the plotter
To Next Page
Loading...