- Vehicle - Tyre calibration
This function allows the user to run the procedure for
calibrating and teaching in the tyre rolling
circumference or to restore their original values.
It also allows you to correctly learn the final drive
ratio (front sprocket/rear sprocket) in the event of
modifications to the approved configuration. Refer
to the table of front sprocket/rear
sprocket combinations for this model, if any.
Then the Tyre Calibration function:
●
if tyres must be replaced
●
if final drive ratio must be changed
Condition for successful calibration:
●
constant speed between 49 and 51 km/h.
●
2nd gear
To open this function:
●
Enter the menu.
●
Use
and to select the “Vehicle”
item and press the
.
●
Select the “Tyre calibration” item and press the
to confirm.
Tyre calibration
DRL
Coming home light
Star calibration
Tyre pressure
Next
Close
Back
Vehicle
120
°C
09:09
am
N
Gear
Fig 140
177
To Next Page
Loading...
