Ducati MULTISTRADA V2 - Light Control

Light control
Low / High beam
By means of  (A) it is possible to switch from
low beam to high beam and vice versa: position (B)
for high beam, position (C) for low beam. To flash,
press the  in position (D).
If engine is not   turning the key to on, it
is  possible to switch on the lights or
flash.
If within 60 seconds from the manual switching on of
the low or high beam the engine is not  the
lights are turned 
To preserve the motorcycle  the headlight is
automatically switched  when  the engine
and it is then switched on again when the engine has

DRL in "Auto" mode – only for version with
DRL lights
If the DRL was set to "Auto" via the "DRL" function
within  - Vehicle” menu, the instrument
panel automatically manages the DRL and the low
beam according to detected ambient light:
B
C
A
D
A
E
Fig 59
78