(e.g. if with level 3 the DWC intervention seems
excessive, switch to level 2; alternatively, if on level 3
you cannot perceive any DWC intervention, switch to
level 4).
Recovery in case of error
If a DWC fault occurs while the DTC system is
switched on, a specific function is activated to inform
the user of the fault in good time. This function is a
modulation of the power output that will be active
during use from the moment the system goes into
fault until the vehicle is switched During this
riding phase, an error message will be present in the
instrument panel. the vehicle is switched
when the vehicle is switched back on, if the system is
still in error, power modulation will no longer be
present but the error status will still be signalled. In
any situation, if the system is switched by the
user, no power modulation will be applied other than
that requested by the user.
219
To Next Page
Loading...
