To align the headlight beam, turn the screws (1) and
(2) located at the front of the vehicle, on both sides.
Stand facing the instrument panel and locate the
two screws to adjust them.
Screw (1), positioned on the side, acts on the
headlight:
●
turn counter clockwise to lower the light beam;
●
turn clockwise to raise the light beam.
Screw (2), positioned on the right side, acts on the
right headlight:
●
turn counter clockwise to lower the light beam;
●
turn clockwise to raise the light beam.
The headlight might fog up if the motorcycle is
used under the rain or washing. Switch
headlight on for a time to dry up any
condensate.
Fig 259
286
To Next Page
Loading...
