To ensure trouble-free operation of the side stand
joint, thoroughly clean it and then use SHELL
Alvania R3 grease to lubricate all friction points.
Do not sit on the motorcycle when it is
on the side stand.
Note
Check for proper operation of the stand
mechanism (two springs, one into the other) and the
safety sensor (2) at regular intervals.
Note
The engine can be with the side stand
down and the gearbox in neutral. If with a
gear engaged, pull in the clutch lever (in this case the
side stand must be up).
The instrument panel receives information on side
stand status and if side stand is down/open, the
display shows the icon “STAMP. LATER." on red
background.
In case of side stand sensor fault, the instrument
panel will display the stand down/up indication with
MIL light on.
If the instrument panel does not receive side stand
status, the stand down/open “STAMP. LATER.”
indication will flash to indicate an undefined status.
45
To Next Page
Loading...
