The side stand must be fully up (in a horizontal
position) as its safety sensor prevents engine
when down.
Note
It is possible to the engine with side stand
down and the gearbox in neutral. When the
motorcycle with a gear engaged, pull the clutch lever
(in this case the side stand must be up).
Move the red switch (1) upwards to the "RUN"
position, uncovering the (2).
Push the (2) to the engine.
Let the motorcycle without operating the
control.
Note
If the is flat, system automatically
inhibits motor cranking operation.
Do not rev up the engine when it is cold. Allow
some time for oil to be heated and reach all points
that need lubricating.
Fig 77
Fig 78
98
To Next Page
Loading...
