5-13
Chapter 5 Troubleshooting Guide
2
Rotate clockwise the emergency stop
switch to release.
If the emergency stop switch is pressed
accidentally during operations, reset it, and
then touch the
key to remove the paper
remaining inside.
1-10. Vertical Conveyance Board Was Opened
If the vertical conveyance board is opened during the collating process, the machine stops immediately.
Restart the process by following the procedures below.
1
Pull the handle of the vertical
conveyance board to open it.
2
If jammed paper remains in the
machine, remove it.
Make sure not to insert hands inside the
machine while it is running, or unjuries may
result.
3
Close the vertical conveyance board.
Unless the vertical conveyance board is closed completely, the collating process cannot be
restarted.
To Next Page
Loading...
