2-35
Chapter 2 Basic Operation
5. Other Settings
5-1. Overlap Amount Setting
If the alignment of the paper ejected to downstream machine is poor, ejecting the collated paper slightly
shifted from its original position can improve paper alignment.
At shipment, this is set to “1”.
• Set to "1" when ejecting to the ejection stacker.
• When two DSC-10/20s are connected, set from tower A.
1
Select the MODE menu.
2
Touch .
The MODE 2 Menu is displayed.
3
Touch the overlap amount key.
Select the appropriate overlap amount referring to the following table.
5mm/
0.4inch
Overlap
amount: 3
10mm/
0.39inch
Overlap
amount: 4
Setting Overlap Amount
1 0 mm
2 2.5 mm/0.1inch
3 5 mm/0.4 inch
4 10 mm/0.39 inch
5-2. Paper Feed Error Standby Setting
Use this setting to activate the waiting mode every time a paper feed error occurs or when paper feed error
occurs twice consecutively in the same bin.
At shipment, this is set to “1”.
• When the ejection direction is set to right ejection, set the number of paper feed error standby sets
to 1.
2 cannot be selected.
• If the interleaf 1 or 2 mode is set, set the number of paper feed error standby sets to 1.
2 cannot be selected.
• When two DSC-10/20s are connected, set at tower A.
To Next Page
Loading...
Need help?
General