Duplo DSC-10/20 - Conveyance Board of LUL-HM was Opened; Machine Auto Backlight Is off

5-14
Chapter 5 Troubleshooting Guide
1-11. Conveyance Board of LUL-HM Was Opened
If the conveyance board of LHL-HM is opened during the collating process, the machine stops immediately.
Restart the process by following the procedures below.
1
Lift up the conveyance board of LUL-HM
to open.
2
If jammed paper remains in the ma-
chine, remove it.
Make sure not to insert hands inside the
machine while it is running, or unjuries may
result.
3
Close the vertical conveyance board.
Unless the conveyance board is closed completely, the collating process cannot be restarted.
1-12. Machine Auto Backlight Is Off
If the machine is not operated for a certain period of time, it enters the auto backlight o mode.
In the auto backlight o mode, the backlight of the display blacks out and the LED turns orange.
1
Touch the panel to return to the normal
mode.
When using two collators, return both towers
to the normal mode.