DURAG D-ISC 100 2 Series - Page 78

6 | Initial commissioning (Quickstart)
78
D-ISC 100 x xx2
Setting See Section
Set the signal inversion 15.11.1 Example: Signal inversion setup (digital out-
puts) [}185]
❑
Parametrise the digital inputs
(
as required )
Setting the target function 15.11 Example: Assignment of digital outputs [}184] ❑
Set the signal inversion 15.12.1 Example: Signal inversion setup (digital in-
puts) [}189]
❑
Parametrise the digital communication interfaces
(
as required )
❑
Setup communication parameters 15.3 Example: Setting / checking DURAG the Mod-
bus [}158]
❑
Table6.1: Checklist for the start configuration