Center blade
Center blade
Entry: on/off
CAUTION:
Switching off the center blade automatically switches off
the corner blades too.
However, switching the center blade back on does not
automatically switch the corner blades back on again.
They must be switched on separately.
Center-blade rpm
Entry: 1700...3000 [rpm]
Select with the “ñ”or“ò”keys.
+ Adjusting the center-blade incision at the seam start
- Changing this value carries out the
fine adjustment of the center-blade incision at the
seam start.
Entry: - 9.9 … + 9.9 0 = no adjustment
+ = switch on center blade
sooner
- = switch on center blade
later
+ Adjusting the center-blade incision at the seam end
Entry: - 9.9 … + 9.9 0 = no adjustment
+ = switch off center blade
sooner
- = switch off center blade
later
4
23
To Next Page
Loading...
