7.3.11 Step-by-step mode
In the step-by-step mode the sewing cycle is halted at important
positions so that individual processes can be checked.
–
Press OK to run the test program.
The main screen appears with a reminder to execute a reference
run.
Info line:
Reference run
–
Push the left pedal down.
The feed carriage moves to the insertion position.
–
The insertion process is completed as in the set program. After the
final stage of the insertion process the following screen appears.
–
Press the right pedal to call the next step. After the final step in
inching mode the program can be restarted with the left pedal.
–
To leave the test program press the RST key or
switch the machine off.
70
To Next Page
Loading...
