4
7.3.12 Determining the cycle time
This program determines the machine’s cycle time.
–
Press OK to run the test program.
The cycle time appears on the main screen.
Info line: Cycle time
Reference run
–
Execute a reference run.
–
When the set sewing program has been completed the cycle time
appears in the display.
–
To leave the test program press the RST key or
switch the machine off.
7.3.13 Dongle-Menu
The dongle is used to memorize sewing programs, sequences and
automat parameters and to transfer these data to other sewing
automats.
The transfer direction is selected with the keys ”F2” and “F4”.
The data transfer is started with the “F5”key.
The exact procedure is described in chapter 4 “Memory dongle”.
71
To Next Page
Loading...
